Before Carbon Fibre became the new best thing to make bicycles and their components from, we were used to just tightening a clamp and the item being clamped staying put. Fine for Aluminium/Steel/Titanium; not so for slippery Carbon Fibre. At best your seat post would gradually slip down leading to irritation and progressively more tired legs and at worst, because you know its a bit slippery, you over tighten and then "snap"....... Time for a new seat post as the last one now has a lovely crack through it! So with this in mind, Carbon Juice is there to give a little helping hand at increasing the friction between previously slippery carbon fibre surfaces. It reduces the chances of slippage and eliminates the need for you to over tighten and risk damaging your lightweight parts. And one small pot will last a very long time as so little is required per application. Simply apply to component interface area's and tighten to manufacturers recommended torque settings.
A little pot of disaster aversion for your carbon bits. Slop a dollop of Carbon Juice on carbon bits to kill creakiness, banish over-tightening and bid farewell to slips and poor grip.
Carbon juice provides a non-slip helping-hand for any of your carbon components and helps keep seat-posts, bars and other bits in place. It’ll help guard against slipping and avoid the risk of you over tightening your clamps and breaking your expensive carbon bits.
Carbon Juice is easy peasy to use. Just blob a thin layer on any of your carbon components where they come into contact with another material. Tighten to the manufacturer’s settings and away you go on your search for two-wheeled glory.